Configuring Arcfra network controllers

Select the number of Arcfra network controllers to deploy.

Choose the configuration for Arcfra network controllers.

If network load balancer is not enabled, you can proceed directly to step 4. If network load balancer is enabled, you need to set the Management VIP for the ANS service.

Batch configure the Cluster, IP address, Subnet mask, and Gateway for Arcfra network controllers.

• Cluster: Select the cluster to deploy Arcfra network controllers.
• Start IP address: (Optional) Based on the IP address allocation table provided by the network administrator, enter the starting management IP address for Arcfra network controllers. The system will automatically allocate consecutive management IP addresses for all Arcfra network controllers based on this IP address.
• Subnet mask: Enter the subnet mask for Arcfra network controllers' management IP addresses.
• Gateway: Enter the gateway address for Arcfra network controllers.

Select the VLAN and set the IP address for each Arcfra network controller individually.

• VLAN: Select the VLAN used by Arcfra network controllers.
• IP address: If you have set the starting IP address for in step 4, the IP address displayed here will be the management IP address automatically allocated by the system. You can also manually enter the management IP address for each Arcfra network controller based on the IP address allocation table provided by the network administrator.